BAND SAW Table Insert / Plate - Two Pack 3" Aluminum - ROCKWELL / DELTA *NEW*

Description

*NEW and IMPROVED*
Set of Two
Solid Aluminum Band Saw Table Inserts.
For: ROCKWELL / DELTA Milwaukee BAND SAWS.
These inserts will fit most Delta models, and many other Brands.
Measurements:  3" Diameter X  3/32" or .090 Thick.
Replacement of the Table Plate allows for better Support, Stability and Accuracy of the piece being cut.
The Narrower the Blade Slot, the Better the Support .
Note-1:
Do Not make the Purchase of this 2-1/2 X 3/32" Insert without having first measured the Insert Pocket on your Bandsaw. It is your
responsibility
to make sure your Bandsaw
accommodates
a 2-1/2" Diameter Insert.
Note-2:
A Metal Punch can be Used on the Edge of the Plate to Create a Bulge or Nipple on the Right or Left Hand Side of the Plate that will Lock the Plate and Keep it from Spinning.
Because of the Slight Variance of the size of the Plate Hole in the different Models of Bandsaw's,
that use this Size of Plate, there could be the need to lightly sand the edge of the Plate for the Proper Fit.
Note-3
: If your Bandsaw Table Plate Cavity has a Indexing Pin. A Notch will need to made in the
Aluminum
plate to
accommodate
the Pin. This can be done by a Hacksaw or the Bandsaw itself and will not hurt the blade, the plate being aluminum. It will then Stabilize the Plate and keep it from Rotation.
Any Question's? Please feel free to Ask.