Warner Brand Engraved Brass Pet ID Dog Tag with three sizes of rivets USA

Description

Warner Brand Engraved Brass Pet ID Dog Tag with three sets of rivets
Machine engraved into the 20 gauge brass tag (bends with collar) with a diamond tip
Purchase includes ONE (1) 20 gauge engraved brass ID tag and three sets of rivets.
Tag Size: ¾” wide x 2 ¾” long
Clean, easy to read font using our computerized engraving machine
Tag has many uses besides dog collars such as jewelry boxes, tool boxes, picture frames, plaques etc.
Customization - 22 characters per line up to 4 lines
Please put tag info in message box.
Note: You will need to put two small holes into your collar before attaching this tag.
Tag Installation Instructions
Place tag in desired location on the collar. Mark your two-hole locations with a magic marker (sharpie).
If you have a leather punch, punch holes big enough for rivets to go through collar. If you do not have a leather punch, you can use a nail and a hammer to go through your collar to make holes.
Split rivets
- Put rivet through tag and collar and on the inside of collar split the rivets with a screwdriver.
prying screwdriver in the split left and right making butterfly wings and then smack flat with a hammer so that rivet is flat with inside of collar.
Cap rivets
- Put rivet through tag and collar, on the inside of collar rivet need to be even or just sticking through your collar (select correct length rivet, you have two to select from).
If your rivet is too long the cap will seat on rivet and your tag will be loose. If too short cap will not set.
Place tag and collar on a hard surface for support. Place cap on rivet tip and smack with a hammer t
o seat cap.